Rumored Buzz on Acceleration Switches in Automatic Pilot Mechanisms Catalog

SE3 deals with traffic for Gigabit Ethernet uplink port 1/2 and traffic in between modules installed in the chassis. SE2 changes internal traffic and forwards traffic bound for the uplink ports to the proper SE for that port. By default, there is no direct internal connection in between SE1 and SE3. As an outcome, traffic coming in on SE1 destined for SE3, or vice versa, should go through SE2, which could potentially create blockage.

Switch Acceleration Setup Modes Change acceleration is supported in various setup modes. The Manager Engine II supports a mesh setup without any uplink connections. With the Backplane Channel module installed, 2 extra modes are supported. Figure 33-1 shows the possible configurations. Figure 33-1 Change Velocity Setup Modes Alternative ANo switch velocity is set up (default).

This mode requires that you enable switch velocity on the manager engine. Choice CFully fit together affiliations exist between SEs; there is dual-link load-balancing between SE1 and SE2 and between SE2 and SE3; Gigabit Ethernet uplink port connections. This mode requires that the Backplane Channel module is set up and that switch velocity is not configured on the supervisor engine.

Some Ideas on KR100417436B1 - Mechanical acceleration switch - Google You Should Know

This mode requires that the Backplane Channel module is set up and that switch acceleration is configured on the manager engine. Setting Up The Latest Info Found Here By default, switch velocity is disabled on the Supervisor Engine II. Before you allow switch acceleration, you require to disable the two front-panel Gigabit Ethernet uplink ports on Manager Engine II.

set port disable mod_num/ port_num Action 2 Enable switch acceleration. set switchacceleration allow disable mod-num This example demonstrates how to the allow switch velocity on the switch: Console > (make it possible for) set port disable 1/1 -2 Console > (enable) set switchacceleration enable 1 Making it possible for or Disabling switch acceleration may impact performance for 1-2 seconds. Do you wish to continue (y/n) [n] y Switch Acceleration on module 1 made it possible for.

Do you desire to continue (y/n) [n] y Switch Acceleration on module 1 disabled. Showing Change Acceleration Details To show switch velocity status, perform this task in fortunate mode: Task Command Show existing status of switch acceleration. show switchacceleration mod_num This example demonstrates how to show the existing status of the switch acceleration feature: Console > program switchacceleration 1 Module 1 has switch velocity enabled.